![]() ![]() After painting the section you can now remove the masking tape and you should be left with a straigh edge (minor touch ups might be necessary)įor the main body we decided on using polystyrene layered in between foam board. While painting make sure to utilize multiple coats of paint so that you obtain a nice, even and vibrant sread of color. After putting the wings together with hot glue we used masking tape to tape off the sections that we wanted to paint in order to obtain a nice clean and straight edge. Using a rabbet joint tool designed for foam board we cut the foam board according to the instructions, making sure that we checked the directions that the blade would travel in, and put the wing together using hot glue. After cutting the wings with an X-ACTO knife and a steel cork-back ruler we aligned them and clamped them so that we could sand them equally. For this we divided the board into three zones: the two outer parts of the wing, and a smaller section that would be used to to create a small incline in the wing. ![]() foam board and divided it so that we ended up with all the parts that we would need to construct the wing. The LEDs would be set into the backpack and the tip of the wings and would blink consantl.įor the wings we utilized 20 in. Thus we designed a circuit using an arduino and 6 5mm LEDs set in parallel. It is especially important to test such things as code for an arduino, which we utilized in our project, to make sure that everything works flawlessly. For this you can either utilize an online software or plan it out by hand. It is always a good idea to plan out your circuit before starting to build and making sure that everything is working before you alter the component, and that the circuit actually works the way that you have designed it. General Circuit: (Explain how we planned out our circuit) wide design, but this would change over the course of the project. ![]() We also decided that we wanted the main LEDs on the backpack, a more black and red color pattern. In this morphological we listed different attributes of what we might want to change such as color patterns, size, led placements, and folding mechanisms. For this step we started with the general idea of what we wanted to do, in our case the Buzz Light year wings, and designing a morphological chart. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |